How to make a network with plastic bottles

 
 


 

Cómo hacer una red con botellas de plástico

Even if you don’t believe it, with plastic bottles you can make a colorful and striking net . We will show you how to do it.

 

 

Red with plastic bottles.

 

A decorative way to recycle plastic bottles is to carry out this project. Follow the step by step and start building your colorful network .

 

Materials.

 

  • The first thing you should have are 3 plastic bottles of different colors.
  • Also five washers.
  • Also a cutter blade without handle
  • 2 screws.
  • A ruler is also necessary
  • Finally a square wooden board.

Instructions.

 

Cutting tool.

 

  • To start, open two holes to the wooden board.
  • Then proceed to place two washers, one over the other in one of the holes. Then place the cutter blade to which you have made a hole.
  • The next step is to pass the screw through the hole until it is screwed to the wood.
  • Then place two more washers in the next hole in the wood.
  • Then the other end of the cutter blade with another hole made.
  • You must also place a washer on the cutter blade and pass the screw until it is screwed to the wood.

With this you will cut the plastic strips.

 
 

 

How to cut.

 

  • To start you must cut the bottles in half.
  • Then grab the bottles by the insert tip on the side of the tool that has 3 washers.
  • The next step is to start rotating the bottle while you pull the plastic thread you get from it.
  • To finish you must do the same procedure with each of the bottles.

How to assemble.

 

  • Start by taking the ruler and marking every 3 cm.
  • Then place the plastic on the edge of the ruler.
  • Then hold the shore with a clamp.
  • The next step is to cross the plastic in Zigzag, taking it from one brand to another.
  • After reaching the end of the rule, start burning with a lighter now, without melting the plastic.
  • Take it out of the rule below, keeping the shape it got.
  • You must also do the same with each color of plastic.
  • Then with two tweezers take the ends of the first color.
  • The next step is to start weaving the mesh by interleaving the colors, joining the tips of the strips obtained.
  • Finally, weave the mesh to the size you want.

 
 

You will get a Maya of the size and color that you want to be very
decorative
.

 

Last entries:

 


 
 

 


 
 

 

If you liked this article, share it with your friends on social networks Thank you!

Comments

comments

Be the first to comment

Leave a Reply

Your email address will not be published.


*